MULTIMEDIA
67
1. Adjust your launch RPMs for optimum
launch/traction, if required.
2. Press the Activate Launch Control button on
the touchscreen or press the Launch button
on the instrument panel; follow instructions
in the instrument cluster display.
Make sure the vehicle is not moving.
Put vehicle in first gear or Drive.
Steering wheel must be centered with
tires pointing forward.
Vehicle must be on level ground.
Apply brake pressure.
While holding the brake, rapidly apply
and hold the accelerator pedal to wide
open throttle. The engine speed will hold
at the RPM that was set in the “Launch
Control” screen.
NOTE:
Messages will appear in the instrument cluster
display to inform the driver if one or more of the
above conditions have not been met.
3. When the above conditions have been met,
the instrument cluster display will read
“Release Brake”.
4. Keep the vehicle pointed straight and
release the brake.
Launch Control will be active until the vehicle
reaches 62 mph (100 km/h), at which point the
Electronic Stability Control (ESC) system will
return to its current ESC mode.
Launch Control will abort before launch
completion and will display “Launch Aborted” in
the cluster under any the following conditions:
The accelerator pedal is released during
launch.
The ESC system detects that the vehicle is no
longer moving in a straight line.
The ESC Off button is pressed to change the
system to another mode.
NOTE:
The Launch Control RPM setting can only be
adjusted while Launch Control is not active.
After Launch Control has been aborted, ESC will
return to its current ESC mode.
CAUTION!
Do not attempt to shift when the drive wheels
are spinning and do not have traction.
Damage to the transmission may occur.
5
21_DT_TRX_SU_EN_USC_t.book Page 67