Docomo Q-port.Phone SH-04D, Инструкция по эксплуатации

Страница: 109 / 188

107
SH-04D_E_07.fm
[107/116]
File Management
Use infrared communication to send and
receive data to and from other handsets which
also support infrared communication.
Send and receive phonebook entries, profiles,
notepads, bookmarks, data shot by camera, data
from Gallery, data recorded by voice recorder, etc.
The handset infrared communication function
complies with IrMC™ 1.1 standard. However,
depending on the data, some data may not be
sent or received even when the other party’s
handset complies with IrMC™ 1.1 standard.
The handset Ir send and receive functions
comply with IrSimple™ standard.
Infrared communication is not available in Offline
mode.
To enter Lock No. and to enter authentication
code are required for sending and receiving all
data items. The authentication code is a password
exclusively for infrared communication. Before
starting data communication, the sender and
receiver must enter the same user-specified
four-digit code.
Face the Infrared ports of the receiver’s and sender’s
handset each other and set the distance between
them to approximately 20 cm or less as shown.
While doing infrared communication, keep the Infrared
ports facing each other and do not move them.
Infrared communication may not function properly in
areas of direct sunlight, directly under fluorescent
lights or near other equipment using infrared signals.
If either of the Infrared ports is dirty, infrared
communication will become difficult. Take care not to
scratch the ports, and wipe off any dirt with a soft cloth.
Insert a microSD Card in advance. However,
sending and receiving just single data may not
require the microSD Card.
When sending data, you can also operate from
each function (menu).
1
In the home screen, [
R
]
/
[Send
and Receive by Infrared]
2
Select an item
Receive : Receive single data.
Receive all : Receive all data.
Send : Select data and send.
: Perform the operation for receiving and
sending at the same time.
:
After the operation for receiving, the handset
waits to receive data. Infrared
communication automatically begins when
data is sent from sender’s handset within
approximately 30 seconds.
Infrared communication
Using infrared communication
When using infrared communication
Approx. 20 cm
or less
Infrared port
15°
15°
Sending and receiving by Infrared
Note that if you select [Delete all before
registration] when receiving all data, all data
registered to the target function are deleted.
SH-04D_E.book 107 ページ ２０１２年２月１３日 月曜日 午後５時１分