1
2
3
4
5
6
7
8
9
10
11
Use the opening lever to
open the lock, and then
pull out the mechanism
unit.
Remove the paper holder
from the printer.
Make sure the power cord
(supplied) and the USB
cable are connected and
the ON/Standby switch of
the printer is set to ON.
Lift the paper lever, raise the front cover
and remove the scrap box.
Set the paper roll on the
paper holder.
Set the roll so that there
is no gap between the
paper and the holder.
Set the paper holder in the
printer, and then rotate
the roll in the direction of
the arrow. Insert the
leading edge of the paper
until you hear the buzzer
sound.
The flashing LED (orange)
turns off.
Opening lever
ON/Standby
switch
Scrap box
Paper lever
Front cover
Hold the paper holder to
prevent it from turning
when rotating the paper.
Set the scrap box and
close the front cover.
Remove the ribbon
cassette from the printer
unit.
Set the new ribbon into
the ribbon cassette.
Rotate the roller in the
direction of the arrow
to take up the slack.
Install the ribbon cassette
to the printer unit.
Close the mechanism unit.
Note : When the mechanism unit is closed, the printer starts
paper initialization. (Five blank sheets are output.) Paper
initialization cuts off the outer layer of the paper that may be
dirty. Note that paper initialization is not carried out if the
printer ON/Standby switch is set to ON after the paper is set.
Take-up
side
Supply
side
Install the cassette
so that the supply
side is at the front.
Printer installation
Checking the contents
Printer unit
Power cord
Ribbon cassette
Paper holder
Explanation booklet
(this document)
For Safe Operation
Start up guide
DIGITAL PHOTO PRINTER
User’s Manual
DP-DS621
Dai Nippon Printing Co., Ltd.
Version 0.20
Start Up Guide
Before using the product, read “For Safe Operation” carefully.
