DNIPRO M RH-100, Руководство пользователя

Страница: 22 / 42

ENG
Rotary hammer
18
• prevent unexpected motor start-up. Do not carry the electric tool connected to the
mains holding your finger on the power button. Prior to plug in the tool, please make
sure that the power button is not locked, i.e.in «Off» position;
• use extension cords while working outdoors. In such a case use only extension cords
intended for outdoor works. They have relevant marking. Extension cords shall be
reeled out for their full length;
• be careful. Be aware of what you do. Keep common sense. Do not operate the
electric tool if you are tired, under medications which include narcotic substances or
medications which can cause sleepiness as well as alcohol or any other substances and
products decreasing attention and concentration;
• check damaged parts. Before to operate the electric tool, it is necessary to carefully
check all parts and connections for damage and make sure that they are in a proper
condition and functionality. Check if movable parts are reliably fixed. Do not
operate the tool if power button is damaged. Damaged parts shall be replaced at
the Dnipro-M service centre;
In order to prevent injuries, use only accessories or tools listed in this Manual or
recommended by the certified sale points and Dnipro-M support services.
•
the tool should be repaired in the authorized service centres using the original
Dnipro-M spare parts only. Otherwise serious damage may be caused to user health.
Safety rules
When working with the tool, follow all operating instructions of this manual (Data sheet),
use the tool carefully, avoid impacts, overloading, exposure to dirt and aggressive media.
In the course of work with the machine, it is necessary to comply with the following rules:
• all makeready works with the machine, its maintenance and repair shall be performed
only when plug is disconnected from mains socket;
• plug or unplug the machine from the mains only when the start button is switched off;
•
mains plug shall be disconnected when you replace accessories, transfer machine
from one place to the other, during work breaks or upon works completion;
• immediately release «ON» button of tool if it accidentally stopped (loss of voltage in
mains, replaceable drilling tool jamming, overload of electric engine);
• you shall work only when front handle is properly installed;
•
use ear protectors;
• use protective goggles;
• during works you shall wear footwear with non-slip sole;
• use close safety gloves during long-term operation, as they decrease level of
harmful vibrations on machine handles;
•
do not carry the machine by the power cable. Do not wind cord around your hand
or other parts of body;
• prevent power cord tightening, kinking or getting under various loads as well as
contact with hot or oily surfaces;
• drill holes or make grooves in walls, panels or partitions, in which hidden wiring
can be located as well as perform other works, during which insulation of electric