DNIPRO M EN-25, Руководство по эксплуатации

Страница: 20 / 32

Electric stapler
16
ENG
Make test shots in a similar material, which is not intended for the further use, in order to
select the required size of consumables and adjust the staple (nail) hammering force prior
to start working.
This model has a feature of the staple (nail) hammering force adjustment.
The hammering force is set with the help of a special knob at the rear side of the stapler.
Avoid foreign objects occurrence in the working area. Be careful when working with a
stapler. In case of the staple or nail jamming, it is necessary to immediately unplug the stapler
from the mains and remove the jammed staple (nail).
8. MAINTENANCE
Maintenance works include:
• visual inspection of the electric tool housing, parts and components, mains cable and
plug, for mechanical or thermal damages;
• cleaning the tool housing from dirt and dust.
In case of mechanical or thermal damages to the tool, contact the Dnipro-M service
centre. Clean the tool housing with a soft cloth regularly (before and after use). Avoid
moisture, dust or dirt ingress into ventilation holes of the housing. In case stubborn stains
appeared on body, remove them with a soft cloth wetted in soap solution or with a special
detergent. Use of abrasive materials, various solvents, ammonia water, gasoline, ethanol,
which can damage the tool, for cleaning is prohibited. Clean metal parts of the tool, as well as
hard-to-reach places, from dust and dirt with a brush.
In case of difficulties during technical maintenance of the product, contact the Dnipro-M
service centre for help.
9. STORAGE
It is recommended to store the tool in a well-ventilated room, at a temperature from -15°C
to +55°C and relative humidity not exceeding 90%. If the tool was stored at a temperature of
0°C or below, you should hold it in a warm room at a temperature of +5°C to +40°C for two
hours before use. This time interval shall be adhered to in order accumulated condensate
could be removed. If you start to operate the tool immediately after being carried from cold,
it may fail. Keep the operating manual and component parts in the original package. In this
case all necessary information and parts will always be at hand.
10. DISPOSAL
Do not dispose electric tools as household wastes! Electric tools taken out of service are
subject to separate storage and disposal in accordance with local environmental legislation.