DMX4ALL AuroraDMX Control, Руководство пользователя

Страница: 12 / 21

AuroraDMX Control
12
RDM
(Firmware V1.1 or higher is needed)
RDM is the short form for
R emote D evice M anagement.
As soon as the device is within the system, device-dependent settings can be occur
remotely via RDM command due to the uniquely assigned UID. An direct access to
the device is not necessary.
If the DMX start address is set via RDM, all address switches at the
AuroraDMX Control must be set to OFF ! A DMX start address set by the
address switches is always prior !
This device supports the following RDM commands:
Parameter ID Discovery
Command SET
Command GET
Command ANSI/
PID
DISC_UNIQUE_BRANCH

E1.20
DISC_MUTE

E1.20
DISC_UN_MUTE

E1.20
DEVICE_INFO

E1.20
SUPPORTED_PARAMETERS

E1.20
PARAMETER_DESCRIPTION

E1.20
SOFTWARE_VERSION_LABEL

E1.20
DMX_START_ADDRESS
 
E1.20
DEVICE_LABEL
 
E1.20
MANUFACTURER_LABEL

E1.20
DEVICE_MODEL_DESCRIPTION

E1.20
IDENTIFY_DEVICE
 
E1.20
FACTORY_DEFAULTS
 
E1.20
DMX_PERSONALITY
 
E1.20
DMX_PERSONALITY_DESCRIPTION

E1.20
SERIAL_NUMBER
1)

PID:
0xD400
1) Manufacturer depending RDM control commands (MSC - Manufacturer Specific Type)