DMP Electronics XTLN, Руководство по установке

Страница: 7 / 16

XTLN/XTLN-WiFi Installation Guide
Digital Monitoring Products
3
InstallatIon
Installation
4.1 Mounting Location Information
A location should be selected that is centrally located between the 1100 Series transmitters used in the
installation. Install the XTLN/XTLN-WiFi away from metal objects. Mounting the panel on or near metal
surfaces impairs performance. When selecting the proper mounting location of a transmitter, refer to the
LED Survey Operation section of the specific installation guide for the transmitter being installed.
4.2 Mounting the Enclosure
The enclosure for the panel must be mounted using the provided #6 screws in the four mounting holes
shown in Figure 2. Mount the enclosure in a secure, dry place away from metal objects to protect the panel
from damage due to tampering or the elements. Mount the panel a minimum of 4 feet from any wireless
transmitters or repeaters. It is not necessary to remove the PCB when installing the enclosure.
Mounting Hole Locations
Network
Connector
RESET
S1
LOAD
S2
BAT
J7
PROG
RED
PWR
MODEL XTLN
TX RF RX
SN
J1
Figure 1: Mounting Hole Locations
Primary Power Supply
5.1 DC Input
Mount the panel near a wall outlet for the Model 372-500 plug-in DC transformer. In addition to powering the
panel, the DC plug-in transformer also charges the back-up battery. The 372-500 must be located within 100
feet of the panel using 22 AWG wire. Use the following steps to connect the plug-in transformer:
OBSERVE POLARITY
1. Using 22 AWG wire, connect the panel PWR first terminal (+) to the positive terminal on the power
supply.
2. Connect the panel PWR second terminal (-) to the negative terminal on the power supply.
3. Plug the power supply into a 120 Volt AC, 60Hz dedicated outlet not controlled by a switch.
Wire Exits for DC
Power Supply
+
Model 372-500
DC Plug-in
Power
Supply
Use 22 AWG for
Power Supply connection
_
RESET
S1
LOAD
S2
BAT
J7
PROG
RED
PWR
MODEL XTLN
TX RF RX
SN
J1
Figure 2: DC Power Supply Connection