DMP Electronics XTLN, Руководство по установке

Страница: 11 / 16

XTLN/XTLN-WiFi Installation Guide
Digital Monitoring Products
7
InstallatIon
Flash LOAD Button
16.1 Description
The XTLN/XTLN-WiFi panel software can be updated via the panel’s Programming (PROG) header. To update
the panel with a new software version, complete the following steps at the protected premise:
Model 399 Cable
1. Connect a DMP 399 Cable from the PROG Header to the serial port of your PC operating Remote Link and
containing the XTLN/XTLN-WiFi RU file.
2. Start Remote Link and create or open the control panel account that matches the panel to be updated.
3. Set the Connection Information Type to Direct with a baud rate of 38400 and choose the appropriate
COM port.
4. Select Panel>Remote Update, then select the correct RU file for the panel.
5. Press and hold the LOAD button, then press and release the RESET button.
6. Release the LOAD button and click <Update> in Remote Link.
7. After the software update is completed, remove the 399 cable and press the RESET button to resume
normal panel operation.
Model 400 USB Flash Module
1. Press and hold the LOAD switch. While holding the LOAD switch, press and release the RESET switch
2. Release the LOAD switch.
3. Connect the USB flash drive to the Model 400 and connect the assembly to the panels PROG header. The
LED on the Model 400 will flash and display steady green.
5. Press and release the load button on the Model 400 to initiate the firmware update. The LED on model
400 will flash slowly. If the LED displays fast flashes it means the firmware update was unsuccessful.
6. The update will take approximately 4.5 minutes and when complete the LED on the Model 400 will
display steady green.
7. Press and release the RESET switch then remove the USB flash drive and Model 400 assembly. For
additional information see Model 400 USB Flash Module Installation Guide (LT-1402).