DMP Electronics CellCom LTE Series, Руководство по программированию и установке

Страница: 25 / 41

CellCom‑LTE Programming and Installation Guide Digital Monitoring Products
21
REMOTE OPTIONS
This option allows you to enter the information needed for remote command/remote
programming operation.
REMOTE KEY
Enter a code of up to eight digits for use in verifying the authority of a receiver to perform
a remote command/programming session. The receiver must give the correct key to the
communicator before access will be granted. All communicators are shipped from the
factory with the remote key preset as blank.
To enter a new remote key, press any select area and enter any combination of up to
8 digits. The numbers you enter appear as asterisks.
REMOTE DISARM
Choose
YES
to enable the communicator to be disarmed remotely. The default is
YES
.
Choose
NO
to disable remote disarming.
REMOTE OPTIONS
RMT KEY:
DISARM NO
YES
SYSTEM REPORTS
This option allows you to select which reports the communicator sends to the receiver.
OPENING/CLOSING REPORTS
Choose NO to prevent sending opening/closing reports.
Choose YES to send opening/closing reports for each programmed area. The default is
YES .
ZONE RESTORAL REPORTS
Specify whether the communicator sends zone restoral reports and when they will be sent.
Choose
NO
to prevent sending restoral reports from the communicator.
Choose
YES
to enable the communicator to send zone restoral reports when a zone
restores from an alarm or trouble condition. The default is
YES
.
Note:
The communicator sends zone restoral reports when a zone that has restored
from an alarm or trouble is disarmed. Twenty‑four hour zones send restorals
immediately.
SYSTEM REPORTS
O/C RPTS NO
YES
RESTORAL
NO
YES DISARM