8
9800 Series Installation and Programming Guide | Digital Monitoring Products, Inc.
Install the 9862 Keypad
9862 Keypads are designed to install on any
single-gang switch box or flat surface. Do not
mount on metallic surfaces or boxes. Follow
these steps to mount the keypad on a wall or
flat surface.
1.
Run 18-22 AWG wire from the desired
keypad location to the nearest
available, non-switched outlet.
2. Connect the supplied 4-pin power
supply harness to the 18-22 AWG wire.
Note that the wire with the white
stripe needs to connect to the positive
(usually red) wire.
3. Feed the power supply harness through the case. See Figure 6.
4. Using the supplied screws, secure the keypad base to a wall or box. Ensure the
tamper switch makes proper contact with the wall.
5. While observing polarity, connect the positive (red) wire to the positive
terminal on the power supply. Connect the black wire to the negative terminal
on the power supply.
6. Plug in the power supply. Connect the other end of the power supply harness
to the 4-pin power connector on the keypad without removing the PCB from
the keypad housing, and snap the keypad into the base.
2
+
_
Figure 6: Install the 9862 Keypad
