DMEGA Mega Power I, Инструкция по эксплуатации

Страница: 7 / 16

7
B. Installation step
(a)
Check the shipping carton for damage. This could detect damage to the unit
which might otherwise be overlooked.
(b)
Take out the vacuum pump from its shipping carton. Inspect the unit for
damage.
(c)
Place the vacuum pump at installation place. Connect Inlet & Outlet hose.
to the vacuum pump. For tightened hose, use hose clamp.
(d)
Connect remote control cable to pump relay cable(twisted red/black cable)
of PCB.
(e)
Turn on vacuum pump power switch and check any leakage of pump &
vacuum level.
3. Maintenance
Daily Maintenance Clean Vacuum Piping System
Clean daily. The vacuum piping should be cleaned using a non-foaming vacuum
system cleaner.
Weekly Maintenance Clean In-Line Filter
Turn OFF the pump motor.
Carefully unscrew the lower bowl from the filter top (Clockwise to loosen) and lift out
the screen. Remove screen and gasket. Clean both and lubricate gasket with using
water.
Properly dispose of the contaminated sediment and disinfectant solution waste.
Replace the screen and make sure the gasket is in place before replacing the bowl.
Check all connecting vacuum, waste and water lines for tightness.