16
Always sand inside curves on the idler drum as shown.
Warning:
Never attempt to sand the ends of a work piece on the idler drum, applying the end of the work
piece to the idler drum could cause the work piece to fly up and result in an injury.
Always sand outside curves on the left side of center on the sanding disc as shown.
Warning:
Applying the work piece to the right side of the disc could cause work piece to fly up( kickback)
and result in an injury.
SANDING SMALL END SURFACES ON THE SANDING DISC
Note:
Use of a mitre gauge (optional accessory) is recommended of this operation.
Always move the work across left side of center on the sanding disc face as shown.
Warning:
Applying the work piece to the right side of the disc could cause work piece to fly up( kickback)
and result in an injury.
Warning:
For your own safety, remove the plug from power source outlet before adjusting your sander.
Note:
Use a combination square to square the mitre gauge to the face of the disc (combination square must be
"true").
