10
Installing Work Table
1.
Place the work table for belt on the work support.
2.
Insert 2- sunk head screws through work table and the work support slot.
3.
Put a 6mm washer and a wing nut on the screws and tighten.
Installing Disc Table
1.
Use 2- M6x16 pan head screw fastening a table support mount on the front of sander.
2.
Place the support table w/scale onto the table support mount.
3.
Put a 6mm flat washer on the table lock knob, and place the knob into the tilt scale plate and mount. Hand
tight it.
4.
Place the table onto support table; align the 4- screw which pre- assembled under the table with the holes of
table support.
5.
Put the external lock washer and hex nut onto the screws, and tighten them.
6.
Adjust the table and retighten the table lock knobs.
Warning:
To avoid trapping the work or fingers between the table and sanding surface, the table edge
should be a maximum of 2 mm from sanding surface.
7.
Loosen 4- M6 hex nuts under the table.
8.
Use a 2,0mm drill bit as a spacer. Place the drill bit between the disc and the inside edge of the table. Hold
the table against the 2,0mm drill bit and tighten the 4- M6 hex nuts.
