User manual for meter with U/I input PD72S
“SCoL”
- basic colour (the second one
becomes “active” colour):
“grEE”
- main colour is green,
“rEd”
- main colour is red.
“C r1”,
- control the display colour according to relay (R1, R2 separate) state:
“C r2”
“oFF”
- control for particular relay is off,
“on”
- control for selected relay is on, the display will change its colour after
selected relay becomes active.
“C AL”
- control the display colour according to alarm situations:
“oFF”
- control is off,
“on”
- control is on, the display will change its colour after alarm situation occurs.
“C Pr”
- this setting enables additional threshold for display colour controlling, detailed
conditions of this control are defined by “
dir
”, “
SEtP
” and “
HySt
” parameters of
“
CoL
” submenu.
“oFF”
- no additional threshold.
“on”
- additional threshold enabled, the display will change its colour after result
satisfy conditions defined by
“
dir
”, “
SEtP
” and “
HySt
” parameters of
“
CoL
” submenu.
“dir”
- this parameter defines the direction of result changes activating change of display
colour:
“morE”
- display will change its colour after the result is higher
than
thrhysteresis
“LESS”
- display will change its colour after the result is lower
than
thr hysteresis
“SEtP”
- additional threshold value (range -999 ÷ 9999). Negative values can be input by
selecting a
“
-
” sign on first digit (to change value use
[^]
and
[v]
buttons).
Threshold is the medium value of relay hysteresis.
“HYSt”
- Hysteresis of colour indication (range 0 ÷ 999). Full hysteresis is equal to 2x
“HYSt”
parameter. The display colour can change when an input signal is out of
threshold-hysteresis
to
thr hysteresis
zone.
Presented parameters should be set to ensure that
“
SEtP
” + “
HYSt
” and “
SEtP
”
–
“
HYSt
” do not exceeds the measure range.
28
