User manual for meter with U/I input PD72S
Press
[ENTER]
at least 2 seconds to accept the changes, after that question
“Set?” is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
in EEPROM) press
[ENTER]
button shortly after
“SEt?”
is displayed. To cancel the changes
press
[ESC]
button shortly after
“SEt?”
is displayed. After that device returns to the menu.
7.2.3. Switch parameters
(“LIST” type)
Switch parameters can be described as a sets of values (a lists) out of which only one of the
options available on the list can be selected for the given parameter. Options of switching
parameter are selected using
[^]
,
[v]
keys.
Short pressing of
[ENTER]
causes in displaying of the acknowledge question (
“SEt?”
). If key
[ENTER]
is pressed again, the changes are accepted, stored in EEPROM end the edition
process finished. Pressing the key
[ESC]
after
“SEt?”
causes in cancelling of made changes
and returning to menu.
Functions of buttons when editing numeric and switching parameters:
While editing numeric parameter:
•
change of current (flashing) digit
•
slide change of value (acceleration, deceleration, direction change)
While editing switch parameter - selection of switch parameter.
If numerical parameter is being edited, a short press of
[ENTER]
button
change edited position. A long press of
[ENTER]
button (at lest 2 sec.)
causes of display a
“SEt?”
ask, which allow user to make sure if change of
the parameter value is correct. If switch parameter is being edited, a short
press of
[ENTER]
button causes of display a
“SEt?”
ask. When
[ENTER]
button is pressed again (while
“SEt?”
is displayed) the new value of the
parameter is stored in EEPROM memory.
Pressing this button operator can cancel the changes done up to now (if they
were not approved by
[ENTER]
button after the
“SEt?”
ask) and come back
to menu
7.3. MENU DESCRIPTION
“- - - -”
-
password checking. If some password different from “
0000
” is set, then every
enter to main menu follows the entering of password. If entered password is correct
then first menu position will be displayed else warning “
Err
”, and unit returns to
measurement mode.
Due to problem with direct displaying of “
m
” and “
K
” letters, they are exchanged with
special signs “ “ for “
m
” and “
“ for K respectively. However, in user manual
letters
“
m
” and “
K
” are used to make it more readable (example:
“modE”, “tc K”
).
22
