DKS 1834, Инструкция по установке и эксплуатации

Страница: 32 / 60

1834-065-B-10-14 30
This programming sequence sets which relay(s) will activate when the system receives a rotary-dial 9 open command from a
residents rotary telephone. The system can be programmed so that only one relay will activate, or both relays will activate. TIP:
The relay that you designate as the primary relay should be programmed to activate from a rotary 9 command.
Factory setting = 010 (only relay 1 activates)
3.3.6 Rotary-Dial 9 Relay
(
s
)
Activation
1. Press and enter your four-digit MASTER CODE ( beep ).
2. Enter the three-digit (1's or 0's only) rotary 9 code , then press ( beep ).
Three-digit positions : 1st digit position - Always Set to “0” , 2nd digit position - Relay 1 , 3rd digit position - Relay 2 .
To activate a relay - enter a 1 in the second or third digit position.
To
NOT activate a relay - enter a 0 in the second or third digit position.
Example: entering 010 will cause only relay 1 to activate. Entering 011 will cause both relays to activate.
3. Press together to end this programming sequence ( beeeeeep ).
?? ?? ?? ??
11
SP SP
55
JKL JKL
00
OPER OPER
This programming sequence will set the telephone entry system to dial out in either a touch-tone or rotary format. Generally,
this will be set for touch-tone.
Factory setting = touch-tone.
3.3.5 Touch-Tone / Rotary-Dial
1. Press and enter your four-digit MASTER CODE ( beep ).
2. Press ( beep ) for touch-tone , OR ( beep ) for Rotary
3. Press together to end this programming sequence ( beeeeeep ).
?? ?? ?? ??
77
PQRS PQRS
00
OPER OPER
00
OPER OPER
11
SP SP
00
OPER OPER