En.10
DK2 CHPW102 man.
ENGLISH
OPERATING INSTRUCTIONS
HOW TO CHARGE THE BATTERY PACK
z
Plug the charger into a 120 volt receptacle. When the charger is connected to
AC household current, the green light is on.
z
When
the battery is properly inserted into the charger and charging (fig.4),
the red light will flash.
z
The
red light will turn off and the green light remains lit once the battery is
fully charged.
z
After the charging is completed, remove the battery pack from the charging
stand immediately. When charging more than one battery pack, allow the
charger 15 minutes rest between charges.
z
After many charge/discharge cycles, your battery may lose its ability to hold a
charge. If so, please replace it. Dispose of batteries at an appropriate waste
disposal facility. Do not throw batteries away in common trash receptacles.
BATTERY INSTALLATION AND REMOVAL
z
To
install: slide battery pack into the bottom of the tool(fig.5) until you hear a
click
. Make sure that the battery release latch (fig.5, A) is in place and battery
is secure before operation.
z
To remove: Press the battery release latch and pull the battery pack out at
the same time.
20V CORDLESS PRESSURE WASHER
1.
Attach the pressure wash unit to the main power unit as shown in fig.6. The
lock and release button (fig.6, L) on top of the power unit should engage the
pressure wash unit.
2. Press the short wand (the brass chuck should be at the other end) into the
pressure wash unit (fig.7, 1) and turn clockwise until it is fixed in place (fig 7,
2).
A
fig.5
fig.6
