©2013
DJI Innovations. All Rights Reserved.
18
Setting the AUX3 Switch
The Z15-5D supports camera video recording. Please wire the right channel of receiver to AUX3 port. Every toggle
is set for start/stop recording.
The Assistant Software
Installation and Usage
Step1: Make sure the driver is installed correctly and has been installed beforehand if you use A2, WKM, ACE
ONE or ACE WAYPOINT.
Step2: Please download the assistant software installer from the
DJI Innovations
website.
Step3: Double click the assistant software installer file and follow the steps to finish installation.
Step4: Run the assistant software.
Step5: Please upgrade the firmware and configure the parameters according to the assistant software
indications if necessary.
Test
Check List Before Flight
Notes:
The gimbal is installed firmly to the landing gear, and the camera is mounted correctly and stably.
All cables are correctly connected, without any connected back to front.
The gimbal video signal cable is in good soldered condition if wireless video transmission module used.
Correct connection between the GCU and RC receiver.
Normal connection between the GCU and flight control system.
Correct camera setup.
Correct Transmitter settings.
The firmware of flight control system has been upgraded to the latest version.
Tips:
Please turn to the Trouble Shooting section in Appendix if an abnormal situation occurs.
