dji MATRICE 200 series, Руководство пользователя

Страница: 95 / 140

7
EN
5. Flight
Toggle the Flight
Mode switch to
P-mode, the safest
flight mode.
Power on the remote controller,
monitor, and aircraft.
Launch the DJI
Pilot app.
Before taking off, ensure that the Aircraft Status Bar in the
DJI Pilot app reads ‘Ready to Go (GPS)’ or ‘Ready to Go
(Vision)’ if flying indoors.
Ready to Go (GPS) DJI Pilot
App
After the monitor is powered on, wait for a pop-up window that asks for a selection of USB device use, and then select “DJI Pilot”. Otherwise, the app cannot be
connected to the remote controller.
Always set an appropriate RTH altitude before takeoff. Please refer to the Disclaimer and Safety Guidelines for more details.
Pull left stick down
(slowly) until you touch
the ground.
Hold for a few seconds
to stop the motors.
To stop the motors mid-flight, press the
RTH button while simultaneously pulling
the left stick to the bottom inner corner.
Stop motors mid-flight will cause the
aircraft to crash. The motor can only
be stopped mid-flight when the flight
controller detects critical error.
Press and hold to initiate the RTH procedure. Press again to cancel.
Manual Landing
Return-to-Home (RC)
Manual Takeoff
Combination Stick Command to start/stop the motors Left stick up
(slowly) to take off
OR
Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or when
there are people nearby.
Always keep your hands on the remote controller so long as the motor is still spinning.
After landing, power off the aircraft before turning off the remote controller.
It is important to understand basic flight guidelines for the
safety of both you and those around you.
Refer to the Disclaimer and Safety Guidelines for more
information.
Learn more:
http://flysafe.dji.com/no-fly
GEO Zones