Dixon ZEETER 422 & 424, Руководство оператора

Страница: 8 / 17

ELECTRICAL SYSTEMS
Keep ail connections clean and tight. Maintain the fluid in the
battery at correct level.
BODY
The body may be washed with a mild detergent and waxed
with any automotive type wax.
TRANSAXLE
For adjustment or repair confer with authorized Dixon dealer
service department. Adjustment or repair by other than
authorized dealer voids warranty.
SPARE PARTS
See your dealer for ordering spare parts or warranty service.
INSTALLING AND REMOVING MOWER
DECK FROM FRAME
1. Attach stabilizer arms to mower deck with pins
and clips as shown on drawing.
2. Attach the Vz" dia. engaging rod with a rollpin
through the engaging cam.
3. Position the drive belt on pulleys.
4. Place mower deck under unit in approximate
operating position with engaging rod through
hole in the floor.
5. Connect drive belt to lower engine pulley, being
certain that belt is inside of belt guides. Loosen
belt keeper by loosening the two rear engine
mount bolts; this will allow belt to be placed on
motor pulley. Retighten engine mount bolts.
6. Attach lift linkage to mower deck on the inside
of the attaching lugs as shown on drawing with
pins and clips. (4 places)
7. Attach stabilizer arms to pivot point on the inside
of attaching bracket with pins and clips.
8. Place engaging handle on engaging rod and fasten with bolt
and locknut.
9. After installing pin clips, rotate pins so that open end of clip
is down.