Dixie Narco DNCB 168, Руководство по обслуживанию и устранению неисправностей

Страница: 8 / 85

ELECTRIC POWER NEEDED
Refer to the cabinet serial number plate to determine the proper voltage and frequency the machine requires
(domestically this requirement is 115 Volts, 60 Hertz). Domestic venders will operate properly at +/- 10% of the specified
voltage. For domestic models this is between 103 volts and 127 volts. The cabinet serial plate also indicates the
amperage of the vender. Single phase, alternating current is required. The vender must be plugged in its own properly
rated circuit with its own circuit protection (fuse/circuit breaker).
DO NOT USE AN EXTENSION CORD.
GROUND THE VENDER
The vender is equipped with a three wire power supply cord and MUST be plugged in a properly grounded outlet.
DO NOT REMOVE THE GROUND PIN OR IN ANY WAY BYPASS THE GROUNDING OF THE VENDER.
If the outlet will not accept the power cord plug, contact an electrician to install a proper AC outlet.
COIN CHANGERS AND OTHER ACCESSORIES
The SIID vender must have a coin changer installed and can have a bill acceptor installed. If the coin changer and other
accessories are not factory installed refer to the instructions received from the manufacturer of the coin changer and
other accessories for proper set-up and installation.
The SIID vender will support the following coin changers:
Multi-Drop Coin Mech (Domestic)
Coinco 9302GX
Mars TRC6510
BILL ACCEPTORS
If a bill acceptor is not factory installed, a bill acceptor interface harness must be ordered from Dixie-Narco. See the chart
below:
Bill Acceptor Interface Harnesses
* Also requires parts from acceptor manufacturer.
Note:
Bill acceptors will be inhibited anytime the door interlock switch is in the center position (service mode enable)
even if service mode time out has occurred restoring the vender to normal operation.
OTHER ACCESSORIES
The SIID Vender is capable of interfacing to Debit Card and Data Recording systems. At this time only a few such
accessories have been tested by Dixie-Narco. If such accessories are to be used check with either Dixie-Narco or the
accessory manufacturer about physical and electrical compatibility before attempting to interface such accessories to the
SIID Vender.
INSTALLING A COIN CHANGER
Hang the coin changer on its mounting plate and secure it by tightening the three securing screws. Plug the coin
changer into the 6 pin socket for MDB changers, in the vender.
CAUTION: The coin changer must be plugged in with the power removed from the door or the coin changer may
not power on properly.
After restoring power, manually load the coin changer coin tubes with at least 10 coins each. Following the program
instructions for the SIID Vender, program each selection for its own vend price. A price of $0.00 is free vend. After the