Dixie Narco DNCB 168, Руководство по обслуживанию и устранению неисправностей

Страница: 33 / 85

2. The Vend Rotor must be in the loading position when the Motor shaft is inserted in the end of the Rotor. See
Fig. 8.
3. Insert the Motor shaft in the Rotor and secure the Motor.
4. Install the Vending Cam on the front shaft of the Motor making sure the Lock Tab is at the 9 o'clock position.
See Fig 7.
5. Install the Adjustable Cam per the instructions given on the previous page.
TO SET THE TIMING OF A WIDE COLUMN VEND MOTOR.
1. Make sure the hole through the rear shaft is in a horizontal plane. (If a pin were inserted in the hole, the pin
would be horizontal). See Fig. 10.
2. Slide the Drive Arm (with linkage attached) on the rear shaft as shown. See Fig. 10.
3. Secure by installing the Groove Pin.
4. With the Oscillator in position, align the hole in the Linkage Arm with the pin of the Oscillator.
5. Slide the Linkage on the pin.
6. Install the Vending Cam on the front shaft of the Motor making sure that the Lock Tab is at 6 o'clock as
shown. See Fig. 11.
NOTE: When the screw holding the Linkage Arm to the Drive Arm is at the 12 o'clock position
(See Fig. 10), the Lock Tab will be at the 6 o'clock position (See Fig. 11).
7. Install the Adjustable Cam per the instructions on page 40.
REAR SPACER
The Rear Spacer, one for each column, is located vertically at the rear of the column. The latch fingers or springs,
adjustable by hand, slide into the holes in the column wall for cans and other package settings.
Note:
Rear Spacers with Springs are not shown.
See Fig. 13, the Latch Fingers are in the open position with the Lock Tabs disengaged.
See Fig. 14, the Latch Fingers are in the closed position with the Lock Tabs engaged. Make sure the tabs are in a locked
position as shown, before loading the Vender.
FOR REFERENCE ONLY
Rear Spacer adjustment holes located in the sidewalls of the stacks.
CLEANING THE VENDER
DO NOT USE A WATER JET OR NOZZLE TO CLEAN THE VENDER.
WHAT TO CLEAN
SIGN FACE
The polycarbonate sign face requires proper cleaning to prolong the service life of this item. It is recommended that you
periodically clean the sign face as follows:
1. Rinse the sign with a soft cloth or sponge soaked in warm water.