1592015820 User manual IC260_261L_D DUO FW1.9 rel. 1.0
Pag. 34 of 149
The MENU key allows to exit from a family to reselect another without exit the Pr2 level.
The MENU key allows to pass to Pr1 starting from a family label.
To exit completely the programming push SET + UP.
Enter the programming level Pr3
Enter the Pr3 “OEM level ”:
1. Push the
SET
+
DOWN
keys together for 3 seconds. The top display shows PAS while the bottom
display shows Pr1 labels.
2. Push UP key for 2 seconds and the top display will show Pr2.
1. Push UP key again for 2 seconds and the top display will show Pr3
3. Push
SET
key and the top display shows a blinking 0, with
UP
or
DOWN
insert the Pr3 password. Push
SET
and, if the value is correct, top display will show the first family of parameters
“ALL”
. Otherwise set
the password again.
4. Select a parameter family with
DOWN
or
UP
keys.
5. Push
SET
to enter, the bottom display shows the first available parameter label while the top display
shows its value.
The user can shows and modify all the paramters belonging to this family.
Parameter status, leds and bottom display in Pr3
Leds 1 / 2 are blinking:
the parameter can not be changed.
All the leds are off: the parameter is available only in Pr3.
Led 4 on:
the parameter can be changed also in Pr2.
Led 4 blinking:
the parameter is visible also in Pr2 .
Leds 3 / 4 on:
the parameter is available in Pr2 and in Pr1.
Leds 3 / 4 blinking: the parameter is visible in Pr1 and in Pr2.
The MENU key allows to exit from a family to reselect another without exit the Pr2 level.
The MENU key allows to pass to Pr1 starting from a family label.
To exit completely the programming push SET + UP.
Move a parameter level from Pr2 to Pr1
Enter Pr2 programming level
Select the parameter and if the led # 3 is off: the parameter is available only in Pr2.
To show the parameter also in Pr1:
1. Keep pushed SET key;
2. Push 1 time the DOWN key and the led 3 should be on, the parameter is now available in Pr1.
To hide the parameter in Pr1:
1. Keep pushed SET key;
2. Push 1 time the DOWN key and the led 3 should be off, the parameter is now removed from Pr1.
Move a parameter from Pr3 to Pr2 to Pr1
Enter Pr3 programming level, here the parameter are all visible:
Select the parameter, if all the leds are off the parameter is available only in Pr3.
To show the parameter also in Pr2 and Pr1:
1. Keep pushed SET key;
2. Push 1 time the DOWN key and the leds 3 and 4 should be on, the parameter is now available also in
Pr2 / Pr1.
To show the parameter only in Pr2:
