Ditel MICRA-D, Инструкция по эксплуатации

Страница: 20 / 60

DISPLAY FORMAT
When the total value is between -9999 and 99999, it is shown
on the display with the letter ‘L’ in the auxiliary digit and with
the red led up and down arrows for positive and negative.
(positive)
(negative)
When the accumulated value exceeds from four digits, the
display alternates a 4 digit high order part (with the letter 'H'
in the auxiliary digit) and a 4 digit low order part (indicated by
the letter 'L' in the auxiliary digit).
(The switching between high and low order parts takes place
at a rate of approximately 2s each part).
3.5.3. Totalizer Option
The totalizer facility can be enabled and disabled by
software.
The totalizer counter shares the same input setup, count
mode and count direction as the process counter but
provides separate decimal point and scaling factor.
Each pulse received at the input increment or decrement
the process and total counters exactly, although the
display value may vary from one to another according to
individual scaling factor and reset operations.
The limits of the display are -9999999 and 99999999
(7 digits with minus sign or 8 digits).
The decimal point can be set to five decimal places.
The scaling factor is programmable between 0.00001
and 99999 as for the process counter.
The totalizer has no possibility to load a user selected
display value in a reset event.
3.5.4. Totalizer visualisation
The total value accumulated since the last reset will be
displayed in the format indicated hereafter, when
pressing on key TOTAL (if activated).
20
20
DISPLAY FORMAT
When the total value is between -9999 and 99999, it is shown
on the display with the letter ‘L’ in the auxiliary digit and with
the red led up and down arrows for positive and negative.
(positive)
(negative)
When the accumulated value exceeds from four digits, the
display alternates a 4 digit high order part (with the letter 'H'
in the auxiliary digit) and a 4 digit low order part (indicated by
the letter 'L' in the auxiliary digit).
(The switching between high and low order parts takes place
at a rate of approximately 2s each part).
3.5.3. Totalizer Option
The totalizer facility can be enabled and disabled by
software.
The totalizer counter shares the same input setup, count
mode and count direction as the process counter but
provides separate decimal point and scaling factor.
Each pulse received at the input increment or decrement
the process and total counters exactly, although the
display value may vary from one to another according to
individual scaling factor and reset operations.
The limits of the display are -9999999 and 99999999
(7 digits with minus sign or 8 digits).
The decimal point can be set to five decimal places.
The scaling factor is programmable between 0.00001
and 99999 as for the process counter.
The totalizer has no possibility to load a user selected
display value in a reset event.
3.5.4. Totalizer visualisation
The total value accumulated since the last reset will be
displayed in the format indicated hereafter, when
pressing on key TOTAL (if activated).