ENG
DEU
30
Commissioning
ENG
5.2.2 Installation
WARNING
Personal injury by electric shock!
If a live wire is damaged during drilling work, there is danger of electric shock.
¾
Inspect the installation place for wires prior to drilling.
¾
Ensure that no wires are hidden behind the spot to be drilled.
¾
Change the place of installation if necessary.
Ö
The commissioning has been performed.
Ö
A suitable place of installation has been selected (see „Selection of installation
place“ page 29).
1. Ensure that no lines are laid at this position.
2. Mark the drilling holes:
Wall installation
: (see fig 5 page 3).
Ceiling installation
: (see fig 4 page 3).
Prior to installation in a corner, drill through the drilling holes of the wall-
mount support with a 3,2 mm drill.
3. Drill the holes at the marked spots with a 5 mm drill, 35 mm deep.
4. Insert the dowels into the bores.
5. Install the wall-mount support with the supplied screws.
6. Insert the motion sensor to the wall-mount support. It will latch audibly.
