Disty distyNotruf pro, Руководство по эксплуатации

Страница: 7 / 35

distyNotruf
pro
, Operating instructions
Possibility 3: Fastening with the Neckband
Mount the belt clip as described above and connect the
snap hook through the hole of the clip.
The lock will open automatically, if the neckband is pulled
with too much force. This will prevent the user from being
hurt, should the device accidentally stick to an obstacle.
Putting into operation
Connect the distyNotruf with the charging cable & power supply (= Charging Set, CS),
plug the power supply into a wall socket and let the distyNotruf charge until the red LED
turns off.
Subscription
There is an in-built algorithm to accelerate the login process in such a way that the
distyNotruf begins by searching for the strongest base station. It is therefore of paramount
importance to ensure that the terminal device is logged-in in the proximity of a base station!
The preset authentication code (AC) is 0000.
The distyNotruf is prepared through the following procedure. The process functions only if
the device is not subscribed. See chapter on “Factory setting”.
The device is plugged into the CS. Press the key within the next 5 seconds and wait 10 sec
for the green LED to light up. Now let go off the key.
The function has now been activated. The green LED begins to flash. This indicates that the
distyNotruf is searching for the base station that is ready for subscription.
The DECT base station is activated for the subscription process. Ensure that no other base
station/DECT system has activated subscription readiness.
You will hear a “Beep” after successful subscription and the device will restart to accept the
data. The subscription process is thus completed and the
distyNotruf
can be removed
from the charger station. The device begins to search for the base station and register itself.
It switches to the “Stand-by state” ( = idle locked ) after successful synchronization.
The green LED will now flash up briefly once in every 10 seconds.
Page 5 of 33