Disty distyNotruf pro, Руководство по эксплуатации

Страница: 26 / 35

distyNotruf
pro
, Operating instructions
Definition of "secret" key combination
Configuration via microphone
To configure a distyNotruf without programming station, it is possible to adjust the
parameter sent by DTMF tones through the microphone. This may be necessary if the base
station uses an AC, which differs from the default setting.
As a prerequisite the
distyNotruf must be unsubscribed.
The function is activated by pressing the alarm button. Both LEDs are illuminated.
Now the device will record the DTMF-tones via the microphone for the next 30 seconds.
For example, the setting of an AC = 0627 would be as follows: ** 9 5 0 6 2 7 #.
To generate those sounds, there are various possibilities. This can be done with a tone
generator, a telephone, mobile phone or a PC - program. In the case of a telephone a
connection is made to any subscriber. Then place the
distyNotruf
near the earpiece or
speaker of the phone, push the button on the
distyNotruf
and now select the above-
described combinations of numbers on the push button at the telephone.
The successful programming is indicated by a positive acknowledgment tone.
If you want to change other parameters, this procedure must be repeated accordingly.
Charging
The illumination of the red LED and a brief beep indicate the end of
battery capacity. To charge, the
distyNotruf is placed in a
charging device ( CS ) designed for this purpose.
Charging takes approximately 4 hours for a complete charging cycle.
Power supply plug:
•
5 VDC, 500 mA ( Type Europlug KA 1504001)
•
Operating temperature: 0 °C to + 40 °C
•
Storage temperature: - 20 °C to + 60 °C
Page 24 of 33
t/s
Taste
an aus aus an
< 1 s
> 2,5 s