DISPLAYLITE ZBT-40 Series, Руководство пользователя

Страница: 9 / 29

Page 7
User’s Manual
Document No: ZBT-User C
To avoid trip hazard , risk of injury and damage, cables should be correctly
routed through the table leg and protected where they exit out of the table.
Where possible use a recessed outlet in the floor for power & LAN
connections. Ideally the outlet should be located immediately under the table.
If this is not possible, ensure that a suitable cable protector is used.
Adjusting the feet
Adjustable feet are provided in the legs of the table to assist with any
unevenness in the floor. To adjust the height, turn the base pad of the foot
clockwise or anticlockwise to raise or lower the height.
Warning
– Care should be taken – Risk of Trapping Fingers.
Refer to image below.
3.3 Connections
The product has been designed so that the external AC power, Ethernet (not
provided) and HDMI cables can be discreetly routed though one of the table
legs. To connect and route your cables, unscrew the 5 x M4 screws that
secure the cable access panel.
Note
– Retain the screws as they will be
required to secure the panel.
With the panel removed locate the internal Power, Ethernet and HDMI
connector that are on flying cables. When you have completed routing the
cables and connected the cables (see below), replace the access panel using
the 5 x M4 screws.
Power In
– Connect the power cable
Route the external power cable supplied with the product through the leg and
attach it to the internal power connector inside the leg.
Note: Only use the power cable provided in the accessory box.
LAN (Ethernet)
- Connect to a network using an Ethernet cable (Zero Bezel
also supports wireless connection). Route the external ethernet cable (not