disperator 8075-E, Инструкция по эксплуатации

Страница: 10 / 36

10 11
Door Assembly
reMoVe aND re-iNstaLL
The heavy-duty door could become dented, scratched
or bent and require replacement. Door removal is also
necessary for some service procedures.
iMportaNt : Firmly support the door during removal
and re-installation.
1. With the door closed, use a 3/16” allen wrench to
remove the lower hinge pin.
2. Carefully remove door by opening and sliding the
bottom of the door away from the cabinet.
3. To re-install, lift the door, insert the upper hinge pin
into the upper door bushing and move the door into
place. Insert the lower hinge pin from Step 1 and
tighten securely.
section B – Cabinet
reVerse Door HiNGe positioN
The compactor comes from the factory with the door
in the right-hand opening position. Use the following
instructions to reverse the door.
1. Remove the door (see Remove and Re-install).
2. Use a 3/16” allen wrench to remove the lower hinge
pin from the cabinet (2 screws).
3. Turn the bracket over and install the bracket on the
opposite side of the cabinet using the same screws.
SCREWS
DOOR
LOWER
HINGE
BRACKET
LOWER
HINGE
PIN
SCREWS
DOOR
LOWER
HINGE
BRACKET
LOWER
HINGE
PIN