User manual in Original
Doc. ref: 500A_DRR-K_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
17 / 44
16 / 44
Hoist alternative 2
Use a firm and well-balanced jack with a support disk to hoist the disposer into position under
the mounting flange.
Hoist alternative 3
If no hoisting tools are available, place the disposer on a solid object of the proper height (for
example a wooden crate), and push it in under the mounting flange. To get the proper height of
this object measure the space between the floor and the mounting flange and then subtract the
height of the disposer and the rubber seal (which is 3 mm thick).
Mounting of models 520, 530, 550 and 575, delivered with legs as standard
The weights of models 520, 530, 550 and 575 require legs for support. At installation site the
seperatly delivered 3 legs must be fixed to the 3 clamps in the disposer bottom plate.
Proceed as follows when mounting the legs:
•
Measure the height (X mm) between the flange of the mounting assembly and the floor/floor
plate.
•
Measure the height (Y mm) of the disposer without legs including the 3 mm rubber seal.
•
Lay down the disposer carefully on its side. Slide the three legs into respective clamp. Each leg
should protrude X – Y - 4 mm.
•
Tighten the clamps. Make sure that the legs are fixated, and that their position have not
changed during the tightening of the screw.
•
Place the disposer so that it stands on its legs. Move the disposer carefully into position under
the flange of the mounting assembly.
•
Using the six screws with nuts fixate the disposer onto the flange with the 3 mm rubber seal
in between. Tighten the screws alternately and evenly until the rubber seal is compressed
approximately 1 mm.
•
Use a jack or a lever to push up the disposer towards the flange of the mounting assembly.
•
While this upward pressure is maintained, untighten each leg and pull it downwards. Make
sure that all legs are firmly pressed against the floor. Tighten the clamps using a torque of 17
Nm. As this is a critical matter, a torque wrench should be used. If no torque wrench is available
use a leaver of approxematly 30 cm and a force of 6 kg.
Содержание 500A-DRR-K EXCELLENT Series
Страница 2: ......
