Dish Network DVR Satellite System, Руководство пользователя

Страница: 86 / 147

78
Sending Discrete Power On and Off
Chapter 10
S
ENDING
D
ISCRETE
P
OWER
O
N AND
O
FF
Discrete power ON and power OFF IR commands are used when programming macro
commands into universal remotes. Using an ON-only or OFF-only command is more
effective than a toggle ON/OFF command when trying to make sure the satellite receiver
is reliably in one state or the other. To send a discrete power ON or OFF command, use
the following steps:
1 Program the remote control to control all the devices that you would like to control.
2
Press SAT until all the Mode buttons light up.
3 Press POWER.
4
Press VOLUME UP for discrete power on. Press VOLUME DOWN for discrete power off.
5 Press any button to end this procedure.
Q
UESTIONS
•
My remote doesn’t control my receiver or other components. What should I do?
– Put the remote control is in the correct mode (page 66).
– Check the batteries (page 11).
– Check the remote control address (page 64).
•
Why does my receiver change channels or display menus at random?
Your
neighbor may have their remote control set on the same address. Change the
address on your remote control and receiver as described on page 65.
1
2
3
5
4
Program the
remote control
Press
POWER
Press
SAT Mode
until all Mode
buttons light up
Press VOLUME UP
for discrete power on
or press VOLUME DOWN
for discrete power off
SAT
Press any
button
to end this
procedure
or