Page 34
Chapter 3
Using the System
dish home Button
Press the
DISH
button on your remote control to use
dish home
Interactive TV
.
Format/Star Button
Press the
FORMAT/STAR
button to toggle through the available
display modes (Normal, Zoom) on widescreen displays.
Recover Button
Press the
RECOVER
button if you accidentally change the
channel or video input on your TV and cannot get the picture
back from your satellite receiver. When you press the
RECOVER
button as described below, the remote control sends commands
to your TV to change channels or video inputs to try to get you back to
watching satellite programming. This procedure works only if you have
accidentally changed the TV channel or video input. It does not recover lost
satellite signal (
See Chapter 4 - Reference
for troubleshooting information).
RECOVER
only works if the remote control has been set up to control the
TV and/or VCR, if connected.
Note
: You may need to press the
RECOVER
button up to 30 times to
recover your satellite TV video.
1. Press and hold the
RECOVER
button until all four mode buttons light,
and then let go of the button. The
SAT
mode button flashes twice and
then all four mode buttons flash three times.
2. Press the
RECOVER
button. Wait for the TV mode button to flash
once and then all four mode buttons to flash once.
3. If you see the
System Info
screen, press the
SELECT/OK
button to
close the screen. You have recovered your satellite video.
4. If you do not see the
System Info
screen, repeat steps 2 and 3 until you
have recovered your satellite video.
Note
: If you have a DISH Network HD monitor, you may be able to use the
SAT
button instead of the
RECOVER
button to restore your TV back to
watching satellite programming. See your
DISH Network HD Monitor
User’s Guide
for details. Other buttons on your remote control that do not
operate your satellite receiver are reserved for future use.
Содержание 138410
Страница 107: ...Appendix Page 118 Notes...
