Bluetooth module installation
In our test vehicle (2001 XJR Premium Audio), the Bluetooth module was secured
to center armrest sidewall (See
Fig. 10
) and is our recommendation. In this
area you will also find the factory phone plug and cigar lighter wiring, either of
which can be used to power the Bluetooth module (see
Fig. 11
).
Warning:
Cigar lighter wiring is prone to noise especially if a USB charger is
installed. Locate a noise free power source or purchase a noise filter. In most
instances, this noise is not related to a bad module.
Fig. 10
Fig. 11
Bluetooth module
Red wire
requires 12V accessory.
(Do not connect to
constant battery supply)
and
Black wire
must be grounded.
Factory connector/Plug
Ignition supply wire
Ground wire
10-pin Female (white)
Pin 10 (light green)
Pin 6 (black)
10-pin Male (yellow)
Pin 10 (white/green)
Pin 6 (black)
14-pin (yellow)
Pin 13 (Green)
Pin 11n (black)
18-pin male (yellow)
Pin 5 (Green)
Pin 11 (black)
1.
If vehicle does not have a phone plug, simply tap into cigar lighter supply
wires under console: White/
Blue
= 12V ACC, Black=Ground.
Fig. 12
2.
Connect 3.5mm audio plug (routed from trunk) to module pigtail jack (See
Fig. 13
)
Fig. 13
Audio out
