17
Operation
Moving the Mower
Drive Wheel Neutral Lever: Located on both sides of the
rear of the frame (see Figure 7). The Neutral Lever is used to
control the relief valve of the hydrostatic transaxle. It releases
the oil pressure, allowing the machine to be pushed without
the engine running.
Transporting the Mower
Use a heavy-duty trailer or truck to transport the machine.
Lock brake and block wheels. Securely fasten the machine to
the trailer or truck with straps, chains, cable, or ropes. Be sure
that the trailer or truck has all necessary lighting and marking
as required by law.
Use extreme caution when loading units on trailers or trucks.
One full width ramp that is wide enough to extend beyond the
rear tire is recommended instead of individual ramps for each
side of the unit. The lower rear section of the tractor frame
extends back between the rear wheels and serves as a stop for
tipping backward. Having a full width ramp provides a surface
for the frame members to contact if the unit starts to tip
backward. If it is not possible to use one full width ramp, use
enough individual ramps to simulate a full width continuous
ramp.
Ramp should be long enough so that the angles between the
ramp and the ground and the ramp and the trailer or truck do
not exceed 15°.
DO NOT attempt to turn the unit while on the ramp, you may
lose control and drive off the side. Avoid sudden acceleration
when driving up a ramp and sudden deceleration when
backing down a ramp. Both maneuvers can cause the unit to
tip backward.
Figure 7
