11
Preparation for Operation
Pre-Start Inspection
1. Make sure safety shields are in place and nuts & bolts are
secure.
2. Check fuel supply. Fill the fuel tank no closer than 1 inch from
top of tank to provide space for expansion.
3. Inspect air cleaner. Clean or replace as needed.
4. Be sure spark plug wire is attached and is tightened securely.
5. Examine underneath and around engine for oil or fuel leaks.
6. Inspect fuel hoses for tightness and fuel seepage.
7. Look for signs of engine damage.
8. Remove excessive debris from muffler area and recoil starter.
Filling with Gasoline
For best results use only clean, fresh, regular grade unleaded
gasoline with an octane rating of 87 or higher. Regular grade
leaded gasoline may also be used; however, combustion chamber
and cylinder head will require more frequent service. See Engine
Owner’s Manual. DO NOT add engine oil to gasoline. DO
NOT overfill fuel tank.
• Always fill the tank with the engine off and cool.
• Always check the fuel level before operation.
• Allow the engine to cool for at least two minutes before
removing the fuel cap.
• Do not fill with fuel indoors or near any source of combustion.
• Do not smoke when fueling or operating the mower.
Fuel Shut-Off Valve is located on the bottom of left fuel tank.
The fuel shut-off valve is used to shut off the fuel when the
machine will not be used for a few days, during transport to and
from the jobsite, and when parked inside a building.
The transmission case has grease installed at the factory.
!
WARNING
