Dirty Hand Tools 100983, Руководство по эксплуатации

Страница: 14 / 28

14
Operating Instructions
PRACTICE OPERATING THE CONTROLS AND USING
THE TILLER WITH TINES OUT OF GROUND BEFORE
BEGINNING TO TILL.
It is important that you know how to use the tiller properly,
keep control at all times, stop the tines and wheels from turning,
and stop the engine if necessary.
Read the entire Operation Manual before using the equipment!
Tilling
1. Adjust depth regulator lever to desired tilling depth. (See page 15)
Note: Raise depth regulator lever up one hole at a time, testing
tiller operation after each raise. Raising depth regulator lever too
high can result in loss of control of tiller!
2. Move the throttle control to fast.
3. Place the tiller in forward by pushing down on the drive safety
control lever-this will engage the wheels and tines.
Note: You can slow the tiller’s forward advance at any time by
putting slight downward pressure on the handlebars. You can stop
the tiller by releasing the drive safety control levers to the neutral
position.
Drive Safety Control Lever
Pulling the drive safety control lever toward the handlebar engages the
wheels and tines. Releasing the lever stops the wheels and tines and
brings the tiller to a complete stop (see Figure 2).
!
WARNING
Pulling the safety
control lever towards the
handlebar engages both
the wheels and tines.
Figure 2