35
3 Preparing the appliance
GB
3.6
Filling the disinfectant tank
1.
Make certain that the power cord has
been disconnected from the socket.
2.
Take hold of the appliance and disinfect-
ant tank as shown (Fig. 16), push the re-
lease buttons in, and pull the tank out of
the appliance vigorously.
3.
Unscrew the tank cap from the disinfect-
ant tank (Fig. 17).
4.
Add the disinfectant carefully and undilut-
ed into a refilling container.
5.
Now carefully pour the disinfectant into the
disinfectant tank using the refilling con-
tainer (Fig. 18).
6.
Refit the tank cap and fasten it (Fig. 17).
7.
Check that it is securely fitted.
8.
Rinse out the refilling container with clear
water.
WARNING:
Health hazard! Always make sure that the
disinfectant is inaccessible to children, par-
ticularly just after filling the disinfectant tank
and before steam cleaning. Also observe
the instructions on the disinfectant bottle.
CAUTION!
CAUTION!
Do not immerse
Do not immerse
the appliance
the appliance
in water!
in water!
16
Disinfectant
only
17
18
WARNING:
Health hazard! Only use the disinfectant
supplied or ordered from us. The device
has been designed for and tested with this
disinfectant. Do not mix this disinfectant .
Other products may make using the appli-
ance unsafe.
NOTE:
If you do not have any original disinfectant
available, leave the disinfectant tank empty.
You can steam clean with the appliance
completely normally. In this case, simply set
the disinfectant regulator to ‘OFF’ (Fig. 22).
NOTE:
Do not overfill the tank. It will hold no more
than 150 ml. Check the level constantly by
looking through the transparent outer wall
and make sure that it does not exceed the
‘MAX’ mark (Fig. 18).
M317.book Seite 35 Mittwoch, 30. März 2011 8:40 08
