DirecTV HIRD-E4, Руководство пользователя

Страница: 84 / 90

HUGHES BRAND DIRECTV PLUS™ DIGITAL SATELLITE RECEIVER
P
AGE
9-4
Using the Remote Control
Once your codes are entered, you are ready to start using your universal remote control. The device
keys allow you to switch from one device to another. Some keys behave in a special way. They control
one device while you are actually in another device mode. For instance, while in SATellite mode,
pressing /- controls your TV’s volume—not a digital satellite receiver volume. This is
because the remote control knows that there is no volume control on the digital satellite receiver.
Advanced feature keys (i.e. , ) are not supported for devices other than your digital
satellite receiver. For other devices, only the primary keys (i.e. and , ) will function.
•
For Sony-brand devices, use the key as the “Enter” key.
•
For RCA-brand devices, the device key (i.e., “TV” or “VCR”) might be the “power on” key and
is the power off key.
Switching the Remote Control to Operate Additional
Digital Satellite Receiver
Your remote control can be reprogrammed to operate additional digital satellite receivers. This may be
necessary in situations where multiple digital satellite receivers are located in the same general area
and can pick up signals intended for each other.
To switch the remote control, simply press and hold the key while entering the receiver ID.
The receiver ID can be 001 through 008. Do not forget the two zeros. Remember to access the
ADVANCED PREFERENCES screen using the keys on the front of the digital satellite receiver to
pair it with the remote control.
The other way to program your remote control to match your digital satellite receiver is to scan for the
correct code.
1. Keep your remote control aimed at the device you want to control during this process. The
remote control will send out the “power” command for the digital satellite receiver.
2. While holding down the SAT key, press the “Mute” key for one full second. Then release the
keys. The SAT key should light and stay lit. If it doesn’t, repeat the process.
3. Once you are in programming mode, repeatedly tap the key to step through the codes,
sending out the power command. This could take up to eight presses. When your digital
satellite receiver shuts off, you have found the code.
4. Press the key to verify that you haven’t missed the code. In order to lock in the code,
press the SAT key again.
The remote will remember the code until you reprogram it.
Identifying Codes that Have Been Stored
You can determine the codes that are stored in your remote control. This may be useful for
reprogramming additional remote controls later on.
1.
Press the device key and the “Mute” key simultaneously.
2. Press the key and count the number of times the red light on the top of the remote control
blinks. Each digit of the three-digit code is separated by a 3-second period the light is off. For example,
if the code number is 021, the light will blink 10 times (for “0”), pause three seconds, blink twice,
pause three seconds, and blink once.
Controlling Other Components Using the AUX Button
Some additional features are available when the remote control is in the AUX mode.