Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
Rev.: 20160908
Installation Type 1a (with CHTHD1/THCHD1 T-Harness)
Page 3
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
30
86
85
87
87a
10
DBALL2
RF
Prog. Button
LED
4
14
12
2
OR
RAP Off:
Yellow/Black:
10
[1]
Parking Light MUX Output:
Violet/Green:
8
[1]
Parking Light MUX Output:
Violet/Brown:
9
[1]
(-) Parking Lights via Relay:
Green/Black:
2
(-) Driver Door Trigger
Violet wire in
driver kick panel
See page 5 for
wiring information
TX
(-) Ground
RX
(+) 12V
To vehicle’s
(+) Parking Lights
White/Violet
Fuse 15A
+12V
ONLY connect for
Dodge Journey.
6:
White/Black:
(-) Hood
Hood Pin
Remote Start Safety
Override Switch
Ignition
Barrel
(vehicle side)
12-pin Connector
(Vehicle side)
12-pin Connector
(harness side)
12-pin Connector
(harness side)
You can connect to either a XL202
RFTD
OR
a SmartStart module.
Refer to the
SmartStart/XL202
Installation Notes
for more information.
CHTHD1/
THCHD1
(optional)
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
[1]
See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
Wires not listed in this diagram are not required for the installation.
This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode with or without a
Plug & Play (
CHTHD1
or
CHTHD2
) T-Harness (Optional). This solution offers three (3) configuration
options to control your system: 3x OEM Lock Remote Start Activation, RF Kit or SmartStart
(all sold separately).