Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
Rev.: 20160908
Installation Type 3b (with CHTHD2/THCHD2 T-Harness R1-R6)
Page 10
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
Also note that this installation is NOT compatible with DBALL2.
10
DBALL2
Prog. Button
LED
4
14
12
2
RAP Off:
Yellow/Black:
10
RF
(-) Driver Door Trigger
Violet wire in
driver kick panel
TX
(-) Ground
RX
(+) 12V
(-) Parking Lights:
Green/Black:
2
30
86
85
87
87a
To vehicle’s
(+) Parking Lights
Fuse 15A
+12V
See page 12 for
wiring information
6:
White/Black:
(-) Hood
Hood Pin
Remote Start Safety
Override Switch
You can connect to either a XL202
RFTD
OR
a SmartStart module.
Refer to the
SmartStart/XL202
Installation Notes
for more information.
8-pin Connector
at ignition switch
(Vehicle side)
Ignition Switch
(Vehicle side)
CHTHD2/
THCHD2 R1-R6
(optional)
8-pin Connector
(harness side)
8-pin Connector
(harness side)
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Wires not listed in this diagram are not required for the installation.
This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode with or without a
Plug & Play (
CHTHD1
or
CHTHD2
) T-Harness (Optional). This solution offers three (3) configuration
options to control your system: 3x OEM Lock Remote Start Activation, RF Kit or SmartStart
(all sold separately).