Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
Rev.: 20160908
Installation Type 4
Page 14
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
10
DBALL2
Prog. Button
LED
4
14
12
2
FT CAN High:
Tan/Black:
3
F
T
C
A
N
Low
:
White
or White/Pink
,
pin 7
F
T
C
A
N
High
:
White/Orange,
pin 6
1
8
(+) Ignition
:
pin 3
(+) Start
:
pin 4
M
U
X
:
V
iolet/Brown
,pin 2
1
Ignition Switch
(connector side view)
Sentry Key Module
near Ignition Switch
(connector side view)
RF
FT CAN Low:
Tan:
4
(-) Ground:
Black:
14
(+) 12V:
Red:
13
(+) Ignition:
Yellow:
8
(+) Start:
Yellow/Red:
11
Multiplex Output:
Violet/Green:
8
Multiplex Output:
Violet/Brown:
9
(-) Parking Lights:
Green/Black:
2
(+) 12V:
Brown:
7
(+) 12V:
Brown/Red:
12
(+) Parking Lights
See page 15 for
wiring information.
30
86
85
87
87a
To vehicle’s
(+) Parking Lights
Fuse 15A
+12V
5-pin
or
6-pin
6:
White/Black:
(-) Hood
Hood Pin
(+) 12V:
Red or
Red/Striped
, pin 5
(-) Ground:
Black or
Black/Striped
,
pin 4
Remote Start Safety
Override Switch
You can connect to either a XL202
RFTD
OR
a SmartStart module.
Refer to the
SmartStart/XL202
Installation Notes
for more information.
HS CAN High:
Orange/Green:
5
HS CAN Low:
Orange/Brown:
6
Use this connection
ONLY with DBALL2.
Diagnostic Connector OBDII
(connector side view)
1
8
16
9
HS CAN High: pin 6
HS CAN Low: pin 14
Refer to the Vehicle
Wiring Reference
Charts on page 15
for Start wire colors
and location.
This guide supports the installation of a DBALL in Remote Start Ready (RSR) mode with or without a
Plug & Play (
CHTHD1
or
CHTHD2
) T-Harness (Optional). This solution offers three (3) configuration
options to control your system: 3x OEM Lock Remote Start Activation, RF Kit or SmartStart
(all sold separately).