24
© 2003 Directed Electronics, Inc. Vista, CA
Remove the two 30-amp fuses prior to connecting these wires and do not replace them until the satellite has
been plugged into the control module. These wires are the source of current for all the circuits the relay satel-
lite will energize. They must be connected to a high current source. Since the factory supplies (+)12V to the key
switch that is used to operate the motor, it is recommended that these wires be connected there.
NOTE:
If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED
wire of the satellite to each feed at the switch.
Connect this wire to the accessory wire in the vehicle which powers the climate control system.
Connect this wire to the ignition wire in the vehicle.
Connect this wire to the second ignition/accessory wire in the vehicle. (See selectable menu feature 2-9.)
NOTE:
For vehicles that do not have a second ignition/accessory wire, this connection is not
required.
If additional current capacity is needed cut this wire, add a fuse adaquate for the circuit to be supplied, and
connect to an additional 12V source.
RED/WHITE (+) 12V input
PINK/WHITE (+) second ignition accessory output
PINK (+) ignition output
ORANGE (+) accessory output
RED (2) (+)12V input for high current outputs