20
© 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
1. First press any button on the remote to clear the alarm page.
2. Press either the
or
button again and the High
Security disarm feature will be activated. The siren will be
silenced and the system will reset to the armed state.
3. Pressing the
button once more will fully disarm the
system and allow the vehicle to be accessed.
disarming without a 2-way remote
If your 2-way remote is lost or damaged, you can manually
disarm your vehicle security system. To disarm the system
without a 2-way remote, you must have the vehicle's ignition key
and know where the Valet
®
button is located. Be sure to check
with your installer at the time of installation for both the location
and the preset response (1-5 presses) of the Valet
®
button.
To disarm the security system,
turn the ignition to the ON posi-
tion. Press and release the Valet
®
button the preset number of times
DRW-35
➜
notes:
The first press of the remote button, while the
remote is beeping, only clears the alarm page (no com-
mand is sent to the vehicle).
The transceiver transmits immediately upon system trig-
ger and does not allow disarm during the first 6 seconds
after trigger.
The 2-way remote will respond with a number of beeps
and LED flashes according to whether a pinswitch, sen-
sor, activated the alarm (and also if NPC is active).
