19
© 2008 Directed Electronics. All rights reserved.
minutes and 1 minute of runtime remaining, it sends the 2-way remote
control a paging signal.
Points to remember
:
If the hood is open or if the brake pedal is pressed, the vehicle will not
remote start.
The remote start shuts down:
When the brake pedal is pressed.
•
The hood is opened.
•
When the remote start command is sent again from a remote
•
control.
When the runtime expires.
•
To drive your vehicle after it has been remote started:
Get in without stepping on the brake.
1.
Insert the ignition key and turn it to the ON position.
2.
Now, step on the brake.
3.
The remote control will play the remote start shutdown tone.
You have
now taken direct control from the remote start system.
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To enable Valet take-over; while the vehicle is running, press
AUX
1 time
and the parking lights will flash after a couple of seconds turn off the
ignition and the car should stay running. Once you exit the vehicle you
can lock the system and the car will remain running. If the vehicle shuts
down, then the unit did not enter valet take-over mode.
