4
Directed Digital Solutions NISS06
© 2019-12-30 Directed. All rights reserved.
Introduction
The NISS06 firmware for Directed Digital Solutions is compatible with specific Nissan vehicles. It is a complete
solution for remote start, security (if applicable), bypass interface, and convenience. This guide provides
information on the installation of the module using NISS06. If you would prefer using this system as a digital
solution, go to www.directechs.com and search for the make, model and year of the vehicle. This will allow
you to find the proper firmware and corresponding installation guide.
Warning!
This module can only be programmed via the web tool, which can be found on www.directechs.com or using the
Directechs Mobile application for mobile devices. Features and functions will become accessible when you connect the module
using the XKLoader.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Keys required for
programming
1
Keys required for
operation
0
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Refer to the "Vehicle wiring reference chart" following each installation type.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with an OEM hood pin.
[2]
The siren is
ONLY
required when enabling the security features during module flashing.
[3]
The vehicle
MUST
be disarmed for the power tailgate to operate.
Additional parts required (maximum required):
6A Diode
0 x 1A Diodes
86
85
30
87a
87
0 x Relay
Resistor 100
Ω
0 x Resistor
Fuse 7.5A
0 x Fuse