14
Directed Digital Solutions NISS06
© 2019-12-30 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 15 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note
: To skip the transponder programming and use convenience features only,
press
the
programming button 5 times. Wait until the LED turns on solid orange then proceed with
step 4.
Must be connected LAST
&
Solid
4
Important!
Do
NOT
depress the brake pedal.
Press
the Push-to-Start button once to turn ON ignition. The LED turns on solid green
for 3 seconds then shuts OFF.
Note:
If the bypass was skipped, the LED flashes orange then turns on solid orange
for 3 seconds and shuts off.
&
&
Green x
3 secs
Off
Do NOT depress
the brake pedal
5
Press
the Push-to-Start button once to turn ignition OFF once the module is successfully
programmed.
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
7
DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the vehicle
and no further action is required. For instructions on how to adjust tach or use Virtual tach,
see page 18 (not needed with hardwired or data tach applications).
Hardwire Tach: Firmware using the Violet/White Hardwire Tach input will require
programming. For instructions on how to program or adjust tach or use Virtual tach, see
page 18 (not needed with hardwired or data tach applications).
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.