Direct Supply Attendant SOLO-DS, Руководство пользователя, Страница: 14 / 33

14
To operate the Attendant ® Bluetooth Column Scale with batteries, you must first install the included
six (6) “AA” size alkaline batteries. Batteries are contained in a battery holder inside the display.
Access is via a removable cover on the back of the display.
Installation/Replacement
To install or remove the batteries, the following steps should be followed:
1. Standing behind the scale, locate the battery cover on the back of the display.
USB
Port
Cover
Push in
here and
slide left
Battery
Cover
2. To install or replace the batteries, first remove the battery cover by pushing in on the arrow and
sliding the cover approximately 3/4" (20mm) to the left and then lifting it away from the display.
3. If installing new batteries, proceed to step 4. If replacing the batteries, remove all six (6) batteries
from the battery holder, then proceed to step 4.
4. Install the six (6) new “AA” size batteries in the
battery holder, noting the polarity markings
located in the battery holder.
5. Replace the battery cover on the back of the display approximately 3/4" (20 mm) from the right side
of the display and then slide it to the right until locks in place (it will click when locked in place).
6. The display should turn on, show all digits and the software version for a few seconds, followed
by a small
o
moving across the display and then show
0.0
on the display.
7. The scale is now ready for operation.
NOTE : If the display did not turn on, remove the battery cover and check for one or more improperly
positioned batteries.
Low Battery
When the batteries are near the point they need to be replaced, LobAt will be shown on the display.
If the battery voltage drops too low for accurate weighing, the scale will shut off and you will be
unable to turn it back on. When the LobAt message is displayed, the operator should replace the
batteries or remove the batteries and plug in the 9V AC/DC adapter.
Automatic Shutoff
The Automatic Shutoff feature will turn the scale off after a period of inactivity (no motion or weight
on scale) to prolong battery life. The period of inactivity for the automatic shutoff is selected during
the setup process of the scale and can be set for up to nine (9) minutes. To turn the scale back on,
you simply press the “ ” key.
Battery Operation