Go to table of contents
DCS_Direct_Jet_1024UVMVP
_Getting_Started_Guide_1.2_030314
20 |
P a g e
Press and hold
until there is sufficient space between the table and the print head to
accommodate the thickness of the substrate being loaded.
Place the top left edge of the substrate flush with the top left corner of the table using the
guides to assure proper placement. Flexible substrates must be placed so that they are
completely flat on the table. Any bubbles or raised areas will cause the print heads to contact
the material and will cause inconsistent output.
Note
The front media table guide (the stainless steel bar at the front of the table) can be raised by sliding it
above the surface of the media table/tacky mat to align the substrate.
Make sure to slide it below
the substrate before printing.
Adjust the screws on the table guide so that the guide stays in place,
but also slides without requiring tools.
Press the material down firmly so that it makes contact with the tacky mat or other hold-down device.
If the substrate requires cleaning, DCS recommends an alcohol wipe.
When using the DCS tacky mat with photo paper, DO NOT allow the photo paper print side to come in
contact with the tacky mat. This will permanently adhere to the tacky mat, ruining both the paper and
the mat.
