Go to table of contents
DCS_Direct_Jet_1024UVMVP
_Getting_Started_Guide_1.2_030314
11 |
P a g e
Remove the warning label over the AC power receptacle.
Plug in main power cord and
flip main power switch to ON.
Caution
If an extension cord is required, ensure the cord is as short as possible. To protect your printer against
damaging voltage spikes, a surge suppressor is strongly recommended. Operate the unit only on 100-
240 VAC, 50/60Hz. The power supply on the Direct Jet is auto-switching. However, if you have any
questions about whether or not you have the correct voltage rating for the power supply DO NOT
attempt to use the unit. Contact your dealer/representative or Direct Color Systems directly.
The Ink Level screen will appear on the LCD Touch Screen. Silence the alarm by hitting any of
the LOW ink lights. The alarm will sound again in 20 minutes if a LOW tank has not been
refilled (see Filling the Bulk Ink System).
Press the
the top left of the LCD screen. Press and hold
to raise the print engine to its
maximum height.
Remove the tape from the media table and shipping
brackets.
Remove the two brackets by unscrewing them from the main
channel.
You cannot simply pull these brackets out.
Do not
dispose of these brackets.
Close and secure front cover.
