Go to table of contents
DCS_Direct_Jet_1024UVMVP
_Getting_Started_Guide_1.2_030314
14 |
P a g e
raise the print engine and height sensor so when new media is place on the media table, it will
clear the sensor when the table moves forward.
Lower Print Engine
Pressing this button when the power is on will move the print engine down. When you have an object
under the height sensor, the print engine will stop once the height sensor has detected the object.
When the button is released, the print engine will automatically raise back up to a preset print height
position.
Caution
Do not move print engine below the height of the table and substrate. Damage may occur if the
print engine and height sensor are not lifted high enough to allow the media placed on the media table
to pass under without interference.
Move Media Table Left
Pressing this button will move the table to the left unless the button is locked out (see Print Home).
Move Media Table Right
Pressing this button will move the table to the right unless the button is locked out (see Print Home).
Trash/Paper Feed Cancel
In the event of a solid #1 light, press the Print Home icon followed by this icon to clear the
error and continue the job.
Print Home
This button only functions when the print engine is on. Pressing this button will bring the table to the
Print Home position, which is the position that the table
must
be in prior to sending a print job. After
the table has been sent to the Print Home position, the media table controls are "locked out" (See
Slow/Unlock).
Automatic Return
Pressing this button toggles between Manual and Automatic Return. When the light is lit, this
indicates that the Automatic Return mode is enabled. In this mode, the table will return to Print
Home on its own after a print job. When in Manual mode, after a print job is completed, the table
will remain at the left limit until the user moves it with the appropriate button.
Slow/Unlock Table
Press to unlock the table after it has been sent to the Print Home position. Press and hold this
button for several seconds to view the slow table movement
screen.
Slow Table Movement
Use the
and
to move the media table at half of the
set speed. This is helpful when setting print engine height
with a new substrate.
